Trunking, Extraction & Compressors

This trunking is modular and designed to mix and match types together into continuous runs, including corner sections using joining brackets. The rugged steel constructed body and facia panel is assembled with tamper proof screws requiring a dedicated driver (supplied).


MP Trunking includes 2 x twin 13A switched sockets internally wired.


MPLV Trunking 1200mm includes 2 x twin 13A switched sockets internally wired; key switched and short circuit protected low voltage facilities being a fixed 5 volt dc supply and dual rail +/- 2-15V variable supply set by reading the accurate analogue volt meter.


See here for workstations.

The fume extraction trunking fits under all of the P.E.C.T. trunking units including corner sections and attaches end to end. The system is designed to work with the 24V soldering iron facility where soldering irons are fitted with a tip extraction accessory which plugs into the face of the system.

Power Requirements: 240V 5A

These self-contained units connect directly to Solder Fume Trunking. The larger SF-SOLDER-EXT features a digital control panel and will service up to 30 extraction ports simultaneously; castors allow easy access to the filters. SF-SOLDER-EXT3 has manual controls and is suitable for between 3 to 15 ports. Air is passed through two stages of filtration, HEPA to remove particulates and activated charcoal to absorb any volatile compounds. Both units are quiet in operation and do not require external ventilation.

A fully-regulated industrial compressor to deliver the required consistent air pressure to trunking fitted with SF-TRUNKOCA1 pneumatic check valves. The compressor is extremely quiet in operation and can be housed in either the mobile or fixed cupboards listed.