3D Printing Materials

Spools and cassettes are not interchangeable so it is essential to select the right material for your machine. Material is supplied in sealed bags. ABS will absorb moisture from the atmosphere so always re-seal bags if part-used spools are to be stored. It is worth noting the quantity of material being ordered and the cost. Catalyst software predicts the amount of material needed so this figure can be used to determine individual part costs.

Products	Price	Buy
Ivory ABS spool (491cc) for uPrint Order Code: TMP-UPR-AP	£154.00
Pack of 5 Ivory Model Spools (491cc each) for uPrint Order Code: TMP-UPR-AP5	£735.00

Support Material

Spools and cassettes are not interchangeable, BST support must not be used in SST machines and vice versa, so carefully check your machine model when ordering. Most parts will use less support material than model material, but the proportion will vary depending on the model and the chosen build-strategy. One support spool for every three/four model spools should be about right.

Products	Price	Buy
Soluble Support Spool for uPrint Order Code: TMP-UPR-SUP	£147.00
Pack of 5 Support Spools (491cc each) for uPrint Order Code: TMP-UPR-SUP5	POA

Model Bases

Models are created by building up from one of these disposable, slot-in bases. A new base should be used for every build to ensure the model has a firm grip and can’t move, curl or part-company with the base during the build. For economy, it is possible to position smaller parts to use a clean area of an already-used model base. Re-using bases is not recommended and can be a false economy. If a model does ‘lift’ then the build will almost certainly be lost.

Products	Price	Buy
24 Plastic Bases for uPrint or uPrint SE (203 x 152mm) Order Code: TMP-UPR-BASE24	£120.00

Stratasys uPrint (Original, purchased before 2011)

Model Material

Support Material

Model Bases

Image Viewer